Skip to content
Veltrix Motorsport
Vehicle Dynamics4 min read

Why Minimum Speed Isn't the Whole Story

Carrying more speed to the apex looks like progress. Whether it is depends entirely on what happens next.

SPEED THROUGH ONE CORNER · TWO APPROACHESHIGHER MINIMUMEARLIER MINIMUMFASTER TO NEXT BRAKING POINT
Illustrative data

Minimum speed is the first number most people look for in a corner. It is easy to read off a speed trace, easy to compare between drivers and intuitively satisfying: more speed at the slowest point of the corner must surely be better. Often it is. But it is one of the most frequently misread numbers in a data session, because it describes a single point on the circuit, and lap time is made over the whole of it.

Why it is so tempting

The appeal is real. Time gained at low speed is worth more than time gained at high speed, so a higher minimum speed can be valuable. The problem is not that minimum speed is unimportant. It is that the number can be raised in ways that make the car slower.

Where the minimum is matters as much as what it is

Two laps can show the same minimum speed and be quite different corners. On one, the slowest point comes early: the car is turned, pointed down the next straight, and accelerating before the apex has passed. On the other, the slowest point comes late and the car is still waiting to rotate when it should be gaining speed.

The position of the minimum is a direct indication of when acceleration begins. An early minimum followed by a clean rise is nearly always preferable to a higher minimum that arrives late and lingers.

The cost of carrying too much

A driver who is told to carry more minimum speed will usually find it by entering the corner faster. The car then runs wide of the ideal line at the apex, cannot be rotated as early, and has to wait before power can be applied. The speed trace shows a higher low point followed by a long, shallow recovery.

Compare that with a lap that gives up two or three kilometres per hour at the slowest point but has the car straight and on full throttle several metres earlier. The traces cross shortly after the apex, and from that point the second lap is faster at every metre until the next braking zone. Over a long straight, the small loss at the apex is repaid several times over.

A corner is not finished at the apex. It is finished at the next braking point.

The opposite mistake

None of this is an argument for slow entries. Over-slowing is at least as common as over-driving, particularly once a driver has been told that exits matter most. Braking too early or too hard gives a low minimum speed and a tidy exit that feels controlled and looks neat — and is slow. The exit can only build on the speed the car arrived with.

The target is the highest minimum speed that does not delay the throttle. Finding it means approaching from both sides.

It depends on what follows

How much to trade depends on the corner's place in the lap.

  • Before a long straight: prioritise the exit. Rotation and early throttle are worth a deliberate sacrifice in minimum speed
  • Before another corner: there is no straight on which to recover an investment, so carried speed matters more
  • In a sequence: the last corner of the sequence sets the exit, and the earlier ones should be driven to serve it
  • In fast corners: the car is hardly slowed at all, and minimum speed is close to the whole story

How to judge it properly

The reliable test is not the minimum speed and not the exit speed, but the time taken from the start of braking to the next braking point. That window contains the whole consequence of the choice. If a change raises minimum speed and the time-delta across that window improves, it was a gain. If the delta gets worse, it was not, whatever the speed trace shows at the apex.

  • Compare minimum speed, but also where it occurs
  • Check the distance from minimum speed to full throttle
  • Compare speed at a fixed point well down the following straight
  • Decide on the time-delta from brake point to next brake point

Minimum speed remains a useful number. It simply needs company. Read alongside throttle position, the location of the minimum and the delta to the next braking zone, it stops being a target in itself and becomes what it should be: one piece of evidence about how a corner was driven.

Want this kind of analysis on your own data?

Start a Conversation